Multi-camera ZynqMP Hailo AI Reference Designs

This is the documentation for the Multi-camera ZynqMP Hailo AI reference designs.

User Guide

• Description
  • Hardware Platforms
  • Software
  • Architecture
• Requirements
  • List of supported boards
  • Supported cameras
• Supported carrier boards
  • List of supported boards
  • Unlisted boards
  • Board specific notes
• Build instructions
  • Source code
  • License requirements
  • Target designs
  • Cross-platform build runner
• PetaLinux
  • Requirements
  • How to build
  • Prepare the SD card
  • Boot from SD card
  • Log in
  • Run and test
  • Known issues and limitations
• Yocto
  • Requirements
  • How to build
  • Prepare the SD card
  • Boot
  • Log in
  • Run and test
  • PYNQ-ZU Wi-Fi
  • Patches and known issues
• Run and test the design
  • Hardware setup
  • Log in
  • 1. Check the PCIe link to the Hailo-8
  • 2. Check the Hailo driver and firmware
  • 3. Run inference on the Hailo-8
  • 4. Check the cameras
  • 5. Configure the capture pipelines
  • 6. Capture frames from a camera
  • 7. Run a camera through the Hailo-8 without a monitor
  • 8. Run the multi-camera demo on the monitor
  • 9. Use an NVMe SSD in the second M.2 slot
  • 10. Check the kernel log
  • Fine-tune the camera picture (ISP controls)
• Advanced: project structure and customization
  • Repository layout
  • Target naming
  • config/data.json and config/update.py
  • Build runner
  • Vivado side
  • PetaLinux side
  • Hailo libraries and applications
  • Modifications layered on the stock BSPs
  • Yocto side
  • Where build outputs land
• Troubleshooting
  • Build failures
  • Hailo-8
  • NVMe SSD in the second M.2 slot is not detected
  • Display
  • Boot-time issues
• Revision History
  • 2025.2 Changes: Yocto flow, NVMe in the second M.2 slot, display and camera fixes
  • 2024.1 Changes
  • 2022.1 Changes